What a carriage headrig is, and why it doesn't count as yard equipment

A carriage headrig is the saw that breaks a log down into cants and boards. It rides on a carriage running along rails inside the mill building. The log gets dogged to the carriage, and the carriage pushes the log past a band or circular blade on each pass. That's the piece of the operation that actually cuts the wood. A log stacker or a knuckle-boom loader doesn't cut anything. It just moves the log from one pile to another, off a truck, or onto the deck in front of the mill.
The distinction matters more than it sounds like it should. When a rep hears "equipment count" from a yard survey or a flyover report, the instinct is to lump everything with an engine and a boom into one bucket. That's where the report and the account stop matching up.
Processing equipment lives inside the mill
The headrig, the edger, the resaw, the trimmer, the planer: these are all processing equipment. They sit inside a building or under a roof structure, bolted to a foundation or at least anchored to a slab, and none of it moves between visits. You won't catch a headrig in an aerial pass because it's under a roof, and even if it weren't, a fixed line inside a structure isn't what a yard equipment count is built to find.
Yard handling equipment is a different animal. Log stackers, mobile log loaders (the big knuckle-boom units running on rubber tires), gantry cranes, overhead cranes running on rail along the log deck. These sit outside, in the open log deck and the finished lumber yard, and they're moving all day, every day the mill runs. They're also the machines that wear out on a visible cycle, the ones that get traded in and replaced when a yard outgrows what it's got.
What counts in a timber yard equipment count
A yard equipment count tallies the mobile and semi-mobile machines working the log deck and the yard, not the fixed line inside the mill. That means:
- Log stackers, the forklift-style units running a grapple or clamp head
- Knuckle-boom loaders, truck-mounted or stationary
- Gantry cranes spanning the log deck
- Overhead traveling cranes on rail
It does not mean the headrig, edger, resaw, trimmer, or planer. Those don't belong in a yard count because they're not the equipment a mill adds or swaps out when the yard gets busier. A mill can run the same headrig for twenty years and still need a third stacker because the deck's carrying more wood than two stackers can keep moving.
That's also why a count of yard equipment paired with a read on log deck volume tells you something a processing-line inventory never will. If the deck's stacked heavier than it was last quarter and there are still only two stackers working it, that yard is short on handling capacity. Doesn't matter whether anything inside the mill ever changes. The processing side and the yard side run on separate replacement clocks, and a rep watching only one of them is missing half the account.
None of this knocks tracking a mill's processing line. It's just a different job with a different answer. Counting a headrig in a yard survey is like counting the stove in a parking lot tally. Wrong location, wrong category, wrong use for the number.
If you're covering sawmill and timber yard accounts and want to know which yards are carrying enough log volume to need another stacker or crane before the mill ever calls, that's the gap this site is built to close with a quarterly count of the machines working the deck.